Chapter 1 Installing Operating System
2.
Setting up Red Hat Enterprise Linux 6 Server
This section describes how to install Red Hat Enterprise Linux 6 Server.
2.1
Before starting setup with OS standard installer
2.1.1 Preparation for hardware
The following steps are required to prepare for re-installing an OS (setup with OS standard installer):
1.
If the POWER LED on CPU/IO module is on, shutdown the OS.
2.
Unplug the power cord from outlet while the POWER LED is blinking.
3.
Perform the preparation process for the server as shown below.
– Install CPU/IO modules 0 and 1.
– Install hard disk drives in slot 0 of CPU/IO modules 0 and 1, respectively.
– Disconnect all LAN cables.
– Disconnect the cable for tape device from the connector on SAS board.
– Disconnect the cable for device from the connector on Fibre Channel board.
•
Install only one hard disk drive in the slot specified here.
Important
•
If the hard disk drive is not a new one, physically format it. See Chapter 3 (3. SAS
Configuration Utility) in Maintenance Guide for physical formatting.
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server
15