NEC Express5800 Series Installation Manual page 58

Chapter 1 Installing Operating System
3. Select [1 List RAID Arrays] on ftdiskadm to check if the striping array md8 (RAID device name is
automatically assigned) is created, its Status is "ACTIVE", and md4 and md6 are displayed in
Member column.
# ftdiskadm
Command action
1 List RAID Arrays
2 List Internal Disks
3 Make Mirroring Arrays
4 Repair Mirroring Arrays (RAID1)
5 Delete Mirroring Arrays (RAID1)
6 Remove Disk Partitions
7 Make Striping Array
8 Delete Striping Array
c Configurations
q Quit
Command: 1
[List RAID Arrays]
Name Partition
=================================================================
< Striping Array
md8
< Mirroring Array (RAID1)
md0 /boot
md1 /var/crash
md2 swap
md3 /
md4
md5
md6
md7
This is the end of the procedure to create striping array. The file system of the created striping array is ext4. If
you want to change the file system name, use mkfs command.
58
(RAID1)
(RAID1)
(RAID1+0)
(RAID1+0)
(Label)
(RAID1+0) >
( - )
>
( - )
( - )
( - )
( - )
( - )
( - )
( - )
( - )
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server
Status Member
ACTIVE md4 md6
DUPLEX (1)sda1 (9)sdi1
DUPLEX (1)sda2 (9)sdi2
DUPLEX (1)sda3 (9)sdi3
DUPLEX (1)sda5 (9)sdi5
DUPLEX (2)sdb1 (10)sdj1
DUPLEX (2)sdb2 (10)sdj2
DUPLEX (3)sdc1 (11)sdk1
DUPLEX (3)sdc2 (11)sdk2