Advertisement
Your TV receives signals from the video recorder (VCR) like another TV station.
You have to select a channel number on your TV and tune it in so that you may watch video
tapes.
If you connect a monitor or a TV set equipped with SCART socket this adjustment will not
be necessary, simply select the AV mode on your TV.
Make sure that you have
Insert a pre-recorded
correctly installed your
video tape into your VCR
VCR as described earlier
and press PLAY on the
in this book.
remote control.
CLK/CNT
Press POWER to turn on
your VCR.
EJECT
Select a TV channel
POWER
number on which you
wish to watch video's.
Don't worry if you don't
Turn on your TV.
have a video-tape to play
at this stage!
If you switch your VCR
on and continue stages
3 ~ 4, instead of seeing
video playback tune your
TV until you see a bright
blue screen.
Tune this channel until
the video picture is sharp
and the sound is clear.
If you have used a
SCART cable you will
not have to tune your TV,
simply select the AV
REW
FF
channel. The AV channel
PLAY
is already pre-tuned for
optimum video playback
REC/
on your TV.
Store this channel on
your TV.
You will need to look at
the TV instruction book if
you do not know how to
do this.
The output frequency of
this video recorder (VCR)
is set at UHF channel 60.
If channel 60 is already
used by another TV
station, or if the picture is
distorted, you can
change the transmitter
channel of your VCR.
Stages 5~8 will show you
how to change the output
frequency of your VCR.
7
Advertisement
