Connecting The Ethernet Cable To The Pmc Module - Motorola 82543 Owner's Manual

4. Use the injector levers to seat the module in the slot by closing the
Note:
Ensure it is seated properly in the backplane connectors. Do not damage
or bend connector pins.
5. When the module you are installing is completely latched, secure it
6. Replace the chassis or system cover(s) and connect the system to the

Connecting the Ethernet Cable to the PMC Module

Refer to
and to
Ethernet connector on the PMC front panel.
1. Connect the Ethernet cable to the RJ–45 connector on the front
For continued safe operation, connect the PMC to Ethernet wiring only.
!
Do not connect the PMC to telephone wiring.
Warning
Gigabit Ethernet/82543 PMC Installation and Use
Continue to gently push until the prealignment guide pegs engage
with the backplane connector (Stage 2) and the injector levers make
contact with the chassis rails. DO NOT FORCE THE BOARD
INTO THE BACKPLANE SLOT.
levers until they latch into the locked position (Stage 3). If the levers
do not completely latch, remove the module from the chassis and
visually inspect the slot to ensure there are no bent pins.
Install the PMC and host board assembly in its proper card slot.
by tightening the captive screws at both ends of the faceplate.
AC or DC power source. Turn the equipment power on.
Table 3-7 on page 3-10
Figure 1-5 on page 1-16
panel of the PMC (see
Installation and Removal
for Ethernet connector pin assignments
for a diagram showing the location of the
Figure 1-5 on page 1-16).
1
1-15