Toro 132-6114 Installation Instructions

Pivot Caster Scraper Kit
Groundsmaster
Model No. 132-6114
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Scraper
Locknut (1/4 inch)
Bolt (1/4 x 5/8)
Installing the Scrapers
1. Locate and make note of the spacers at each pivot
caster (Figure 1).
1. Cap
2. Remove the pivot casters from the mower decks.
3. Using a scraper as a template, mark and drill 9/64 inch
holes into each pivot caster as shown in
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® 4000 or 4100 Series Rotary Mower
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
g033130z
Figure 1
2. Spacers
Figure
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
4
8 Install the scrapers.
8
11.4 cm
(4-1/2 inches)
1. Use the scraper as a
template.
4. Install the scraper to each pivot caster with 2 bolts (1/4
x 5/8) and 2 locknuts (1/4 inch)
2.
Form No. 3398-328 Rev A
Installation Instructions
Use
1
Figure 2
2. Mark and drill 9/64 inch
holes.
(Figure
Original Instructions (EN) All Rights Reserved *3398-328* A
Printed in the USA.
2
9.8 cm
(3-7/8 inches)
g033134
3).