Advertisement
Quick Links
Fuel Kit
Groundsmaster
Model No. 139-1000
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note:
Determine the left and right sides of the machine from the normal operating position.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
4000 Series Rotary Mower
Description
No parts required
No parts required
No parts required
Fuel cooler
Hose clamp
Bolt (1/4 x 5/8 inch)
Fuel cooler bracket
Hose (long)
Hose (short)
Foam (short)
Foam (long)
Push-in hose clamp
Worm clamp
Carriage bolt (1/4 x 3/4 inch)
Nut (1/4 inch)
Grommet
Register at www.Toro.com.
Form No. 3431-516 Rev A
Installation Instructions
Qty.
–
Order the radiator support.
–
Prepare the machine.
–
Remove the existing bracket.
1
2
1
1
Assemble the hoses to the fuel cooler.
1
2
2
2
2
4
Install the fuel cooler.
4
2
Original Instructions (EN)
All Rights Reserved *3431-516* A
Printed in the USA
Use
Advertisement
Related Manuals for Toro 139-1000
Summary of Contents for Toro 139-1000
- Page 1 Form No. 3431-516 Rev A Fuel Kit Groundsmaster ® 4000 Series Rotary Mower Model No. 139-1000 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Order the radiator support.
-
Page 2: Preparing The Machine
If your machine does not have existing holes, leaving the operating position. order a radiator support, Part No. 139–0952–03, Repair all bent or damaged areas on the from your authorized Toro distributor. machine and replace any missing parts. Clean any debris from the machine to ease installation. - Page 3 Removing the Existing Bracket and Fuel Hose No Parts Required Procedure Remove the existing fuel hose shown in Figure g287454 Figure 3 1. Nuts 3. Bolt 2. Radiator bracket Remove the 2 bolts on each side of the radiator (Figure Remove the 3 bolts at the bottom of the radiator on each side (Figure...
- Page 4 Assembling the Hoses to the Fuel Cooler Parts needed for this procedure: Fuel cooler Hose clamp Bolt (1/4 x 5/8 inch) Fuel cooler bracket Hose (long) Hose (short) Foam (short) Foam (long) Push-in hose clamp g287327 Figure 4 1. Long hose 6.
- Page 5 Installing the Fuel Cooler Parts needed for this procedure: Worm clamp Carriage bolt (1/4 x 3/4 inch) Nut (1/4 inch) Grommet Procedure Install the grommets into the radiator support (Figure g287432 Figure 6 1. Worm clamp 3. Short hose 2. Long hose g287430 Close the hood and check the seal around the Figure 5...
- Page 6 Notes:...
- Page 7 Notes:...