Universal Groomer Drive MVP Kit
Reelmaster
or 7-inch Reel
Model No. 133-0150
Model No. 133-0151
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
18-inch, 22-inch, or 27-inch Cutting Units with 5-inch
Description
No parts required
No parts required
No parts required
Extended splined insert (right-hand
threads)
Extended splined insert (left-hand
threads)
Flange locknut (3/8 inch)—Model
133-0151 only
Weight bracket
Hex-socket, button-head bolt (3/8 x 3/4
inch)
Right (yellow) reel adapter
Left (green) reel adapter
Groomer drive box
Hex-socket-head bolt
Pivot hub
O-ring
Idler assembly
Bearing shield
Adjuster collar
Stub-shaft assembly
Flange nut (3/4 inch)
Flange locknut (3/8 inch)—Model
133-0150 only
Jam locknut (3/8 inch)—Model 133-0151
only
Left HOC bracket assembly
Right HOC bracket assembly
Adjuster pin
Cotter pin
Flange locknut (3/8 with 5/8 hex)
Cap
Register at www.Toro.com.
Form No. 3421-332 Rev C
Installation Instructions
Qty.
–
Prepare the machine.
–
Gather the tools required for setup.
Determine where on the cutting unit to
–
install the groomer.
1
1
Prepare the cutting unit.
2
1
2
Install the groomer drive box and weight.
1
1
1
2
1
1
1
2
1
Install the idler assembly.
1
1
2
2
1
1
Install the HOC bracket assemblies and
2
the front roller.
2
2
Install the groomer drive cap (For
1
universal groomer assemblies with no
rear roller brush kit installed only).
Original Instructions (EN)
All Rights Reserved *3421-332* C
Printed in the USA
Use