Philips CoolSkin HQ 671 Service Manual

Philips Domestic Appliances and Personal Care
Service Manual
T1
Mains
G
C R
Power plug
Power module
TIPS FOR REPAIR
- Remove the shaving unit to prevent damage during repair.
- Remove the slide cover (item 21) and cartridge (item 20).
- Push the edge of the hair chamber up with your thumb
until the snap connection unlocks (see 'X' in exploded
view).
- Remove 3 A1 screws.
- Remove the cover (item 14).
- Use a screwdriver to push the connecting plate (item 17)
up at a connecting strip ('Z' in exploded view).
- Tilt the motor slightly to detach the snap hooks of the hair
chamber.
- Lift the motor and the PCB out of the housing.
- The cover (item 14) contains a sticker that is permeable to
gas yet impermeable to water.
- This sticker may not be removed under any circumstances.
- The entire drive unit (item 10) is supplied as a single part
to guarantee optimal sealing of the gear shafts.
- When reassembling the shaver, the sealing ring (item 2)
must be placed onto the housing.
Published by Philips Domestic Appliances and Personal Care
4322 277 00484
01/02
D1a D1b
D3 C1
R6
D2
R1
R
TS1
L1
TS3
TS4
D4 R2
TS2
R3 C3
R4
R5

Rechargeable shaver

R31
C44 L41
C2
IC41a
IC41b
R43
≤1
≤1
R41
SK1
C31
TS41
R42
C43 C42
TECHNICAL DATA
Input voltage
Power consumption
Motor voltage
Battery
Battery capacity
Charging indicator
Charging time
Charging current
Charging device
Shaving heads
Shaving emulsion
Mains shaving
SAP CODING
- A new sealing ring must be used to ensure a proper
sealing of the shaver.
- To guarantee that the shaver is completely watertight, only
the original screws may be used.
Printed in the Netherlands © Copyright reserved
HQ 671/A
CoolSkin
C25 D43 PM
MF2
D41
IC41c
R46
≤1
TS41
R44
IC41d
D42 R47
C45
≤1
R45
: 100-240 V, 50/60 Hz
: max. 9 W
: 1.2 V
: 1x NiCd AA
: approx. 700 mAh
: 1x LED green charge
: approx. 8 hours
: 0.2 C continuous
: HQ 600 external transformer
: HQ 167 - 4222 036 04250
: HQ 160 shaving emulsion
: HQ 161 fresh gel
: no
: HQ 671
Subject to modification
A
NiCd
AA