CRU replacement for 5U chassis
NOTE: Unless noted otherwise within a passage pertaining to a particular CRU, the replacement procedure
should be completed within two minutes of the removal of the defective module.
Accessing drawers
To observe or replace a DDIC, you must open the drawer in which it resides. The top drawer (Drawer 0) and the
bottom drawer (Drawer 1) are accessed from the enclosure front panel. See also
Opening a drawer
1. Verify that the anti-tamper locks are not engaged. The red arrows on the locks point inward if the locks are
disengaged as shown in
bit.
Figure 92 Drawer front panel details
2. Push the drawer latches inward and hold them as shown in
Figure 93 Opening a drawer (1 of 2)
Figure
92. If necessary, unlock them by rotating counter-clockwise using a Torx T20
Figure 25 (page
Figure
93.
CRU replacement for 5U chassis
33).
133