Table of Contents
Advertisement
2.4.
Sensor Board, Motor and Pickup Solenoid
Before handling, remove the Left Cover (see Section 1.1).
(1)
Remove the Sensor Board [2 screws (A)].
(2)
Disconnect the connector CN3201 from the Sensor Board.
(3)
Remove the Motor [screws (B)].
(4)
Disconnect the connector CN4 from the Feeder Board.
(5)
Remove the 2 screws (C) from inside of the Feeder.
(6)
Remove the Pickup Solenoid.
(7)
Disconnect the connector CN3 from the Feeder Board.
9
KX-CLPF1
Advertisement
Table of Contents
