Advertisement
Quick Links
Stump Grinder Fit-Up Kit
TX 1000 Compact Tool Carrier
Model No. 23172
This product contains a chemical or chemicals known to the State of California
Note:
Determine the left and right sides of the machine from the normal operating position.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
Description
No parts required
Right shield bracket
Left shield bracket
Bolt (1/4 x 3/4 inch)
Locknut (1/4 inch)
Shield support
Shield
Bolt (1/4 x 1-1/2 inch)
Washer
Locknut (1/4 inch)
Quick-attach assembly
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
1
4
4
2
1
8
8
8
1
Form No. 3413-793 Rev B
Installation Instructions
Use
Prepare the machine.
Install the shield brackets.
Assemble the operator shield.
Replace the quick-attach assembly.
Original Instructions (EN)
All Rights Reserved *3413-793* B
Printed in the USA
Advertisement
Related Manuals for Toro 23172
Summary of Contents for Toro 23172
- Page 1 Form No. 3413-793 Rev B Stump Grinder Fit-Up Kit TX 1000 Compact Tool Carrier Model No. 23172 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Preparing the Machine No Parts Required Procedure 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Lower the loader arms. 4. Shut off the engine and remove the key. g036689 Figure 1 Installing the Shield Brackets Parts needed for this procedure: Right shield bracket...
- Page 3 2. Drill a hole (9/32 inch) through the frame at each marked location. 3. Install the left shield bracket on the left frame using 2 bolts (1/4 x 3/4 inch) and 2 locknuts (1/4 Assembling the Operator inch) as shown in Figure Shield Parts needed for this procedure:...
- Page 4 5. Torque the large bolt (1 x 2-1/4 inch) to 406 N∙m (300 ft-lb), and torque the small bolts (1/2 x 1-1/2 inches) to 101 N∙m (75 ft-lb). 6. Route the hoses through the hose loop (Figure Replacing the Quick-Attach Assembly Parts needed for this procedure: Quick-attach assembly...