Advertisement
Quick Links
Back-Up Alarm Kit
RT1200 Trencher
Model No. 25427
Model No. 25427E
Note: Install software revision G or higher before installing this kit. Refer to your Authorized Toro Dealer for the software
update.
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Bracket
Alarm
Bolt (M6-1x20)
Nut (M6-1)
Wire harness
Cable ties
No parts required
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
1
1
2
2
1
6
–
Register at www.Toro.com.
Install the alarm.
Install the wire harness.
Check the alarm.
Original Instructions (EN)
All Rights Reserved *3394-785* A
Printed in the USA.
Form No. 3394-785 Rev A
Installation Instructions
Use
Advertisement
Related Manuals for Toro 25427
Summary of Contents for Toro 25427
- Page 1 Back-Up Alarm Kit RT1200 Trencher Model No. 25427 Model No. 25427E Installation Instructions Note: Install software revision G or higher before installing this kit. Refer to your Authorized Toro Dealer for the software update. WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
- Page 2 Installing the Alarm Installing the Wire Harness 1. Remove the existing bolts from the back of the 1. Remove the four bolts securing the kick plate to the machine (Figure frame and remove the plate (Figure 2. Install the alarm to the bracket with 2 bolts (M6-1 x 20) and 2 nuts (M6-1) (Figure 3.
- Page 3 6. Secure the harness under the cab to the main harness with the cable ties. 7. Install the kick plate and foot plate. Checking the Alarm • Check and ensure the alarm is working by turning the ignition key to on (do not start the machine) and push the traction pedal to the reverse position.