Toro Groundsmaster 31511 Installation Instructions

Horn Kit
Groundsmaster
Model No. 31511
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
Note: Determine the left and right sides of the machine from the normal operating position.
1
Preparing the Machine
No Parts Required
Procedure
1. Move the machine to a level surface and set the parking
brake.
2. Shut off the machine and remove the key.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® 4000 or 4100 Series Rotary Mower
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
No parts required
Horn
Horn switch
Horn button (rubber)
Bolt (5/16 x 3/4 inch)
Flange nut (5/16 inch)
No parts required
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
1
1
1
1
–
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
3. Disconnect the battery; refer to your Operator's Manual.
Form No. 3399-118 Rev A
Installation Instructions
Use
Prepare the machine.
Install the horn.
Test the horn function.
Original Instructions (EN) All Rights Reserved *3399-118* A
Printed in the USA