NOTE:
NOTE:
38
Step 3: Starting up auto assign (resident) program
This section describes how to start up auto assign (resident) program.
•
It is recommended to load the auto assign (resident) program into IPL.
1.
Login as a user with QSECOFR authority.
2.
Execute the command below to add a library "WTEC02" to
the top of the library list.
ADDLIBLE WTEC02
3.
Execute a command [STRTECPRT] + [F4]. Then select the
name of OUTQ that you specified at the installation or setup,
a job queue to use and its library. Then press the execution
key.
•
If you use a job queue and the library at their initial values, this program will run
within QBATCH.
AS/400 Print Solution — Installation