Advertisement
Procedure
12
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
2
Gathering the Tools
Required for Setup
No Parts Required
Procedure
•
Torque wrench—5.2 to 6.8 N∙m (46 to 60 in-lb)
•
Torque wrench—115 to 129 N∙m (85 to 95 ft-lb)
•
Torque wrench—135 to 150 N∙m (100 to 110 ft-lb)
•
Reel driveshaft tool, Part No. TOR4074 (used only
on 7-inch reels)
Description
Carriage bolt (5/16 x 2-1/4 inches), Part
No. 3230-7—sold separately
Carriage bolt (5/16 x 3-1/4 inches), Part
No. 3230-13—sold separately
Carriage bolt (5/16 x 4-1/2 inches), Part
No. 3230-30—sold separately
Spacer
Flange nut (5/16 inch)
Locknut (5/16 inch), Part No.
3296-47—sold separately
Weight
Small weight (Part No.
132-0734-03—sold separately)
Qty.
1
1
1
Install the weights (rear cutting unit with
2
groomer only, with rear grass basket).
1
2
2
6
3
Determining the Setup
No Parts Required
Procedure
Use the following diagram to determine the position of
the groomer kits and reel motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
Note:
If a groomer kit and a rear roller-brush kit are
going to be installed on the cutting unit, install the
groomer kit first.
3
Use
Figure 2
4. Left-hand groomer kit
5. Reel motor
6. Right-hand groomer kit
g034633
Advertisement
