Advertisement
Figure 8
1. Internal reel-shaft
2. Weight bracket
3. Hex-socket, button-head
bolt—3/8 x 3/4 inch (2)
3.
Apply medium-strength thread-locking
compound (such as Blue Loctite® 243) to the
threads of the internal reel-shaft
4.
Attach the groomer drive box to the reel shaft
(Figure
8) using the hex-head on the groomer
drive box.
Important:
The reel threads on the left side
of the cutting unit are left-handed, and the
reel threads on the right side of the cutting
unit are right-handed.
5.
Restrain the reel for installation; refer to
Restraining the Reel Installing Threaded Inserts
(page
19).
6.
Torque the hex-head to 135 to 150 N∙m (100 to
110 ft-lb).
Important:
You must use a 6-point socket
with heavy wall.
Important:
Do not use an impact wrench for
this step.
Important:
Allow the thread-locking
compound to cure for 15 minutes before
continuing the procedure.
g228117
4. Groomer drive box (left
drive shown)
5. Hex-head (Torque to 135
to 150 N∙m (100 to 110
ft-lb))
(Figure
8).
6
Installing the Idler
Assembly
Parts needed for this procedure:
6
Hex-socket bolt (3/8 x 3/4 inch)
3
Pivot hub
3
O-ring
1
Idler assembly (left)
2
Idler assembly (right)
6
Jam locknut (3/8 inch)
Procedure
1.
Position the idler assembly on the opposite side
of the reel from the groomer drive box.
2.
Install the O-ring onto the pivot-hub assembly.
3.
Apply anti-seize compound on the outside
diameter of the pivot-hub assembly
1. Jam locknut—3/8 inch (2)
2. Hex-socket bolt (3/8 x 3/4
inch)
3. Pivot hub
4.
Secure the pivot hub over the idler assembly to
the reel using 2 hex-socket bolts (3/8 x 3/4 inch)
(Figure
9).
5.
Loosely install the 2 locknuts on the pivot hub
(Figure
9).
6
(Figure
Figure 9
4. O-ring
5. Idler assembly (right side
shown)
6. Apply anti-seize
compound on the outside
diameter of the hub.
9).
g192297
Advertisement
