Output Relays - Toshiba 18 - 1250 A Instruction Manual

TE Series Digital Solid State Soft Starters 18 – 1250A
5.6.10

Output Relays

There are three programmable relays (rated 240VAC, 5A, 1200 VA) in
the TE Series. They can be programmed for change of state indication
for any one of the 25 conditions identified in the following chart.
F060 = Aux Relay 1: Form C (SPDT)
Factory Setting = 1 (Run / Stop)
Range = 1 - 26 (See list)
Use to program the desired operation for Relay # 1.
F061 = Aux Relay 2: Form C (SPDT)
Factory Setting = 2 (At Speed / Stop)
Range = 1 - 26 (See list)
Use to program the desired operation for Relay # 2.
F062 = Aux Relay 3: Form A (SPST, N.O.)
Factory Setting = 16 (Any Trip, 5 - 15)
Range = 1 - 26 (See list)
Use to program the desired operation for Relay # 3.
F063 = Aux Relay Delay Timer for Settings 23 – 26
Factory Setting = 0 (Disabled)
Range = 1 – 999 seconds, or 0 (Disabled)
Use to program the desired On Delay for any Aux. Relay that
has been programmed for Settings 23 through 26 from the chart
below.
Setting
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
*NOTE: Flash rate for Setting #17 is ½ second On and Off
Table 5.6.10: Output Relay Programming
F064 = Reserved
56
Relay Operation Description
Run / Stop (Changes on Start Command, resets on Stop)
At Speed / Stop
At Speed / End of Decel
Start / End of Decel
Short SCR Trip
Phase Loss Trip
Shunt Trip
OL (Motor Thermal Overload) Trip
OT (Starter Thermal Over Temperature) Trip
Short Circuit Trip
Current Unbalance Trip
Over Current (Shear-Pin) Trip
Under Current Trip
Ground Fault Trip
Phase Rotation Trip
Any Trip (#5 - #15)
Any Trip, (#5-#15) flashing output*
Coast Down Time Lockout
Starts Per Hour Lockout
Time Between Starts Lockout
Any Lockout (#18-#20)
Run Timer (F030) Engaged
Run / Stop with On-delay from F063
At Speed / Stop with On-delay from F063
At Speed / End of Decel with On-delay from F063
Start / End of Decel with On-delay from F063