Panasonic PAW-160MAH2L Installation Instructions Manual page 89

Changing values in the "Parameter" menu
To change the values of control parameters, perform the following steps:
1. Press and hold the
The PV display shows "ALI", while the current setting in the SV display is blinking.
Note: After 30 seconds of idleness, the display automatically returns from parametrization
view to normal view.
2. Press the button repeatedly to select the parameter to be changed.
The sequence of parameters and their range of valid values are shown in the table below.
3. Once the PV display shows the parameter to be changed and the blinking SV display shows
the currently set parameter value, use the
meter value
4. Confi rm the new setting by pressing the
5. If more than one parameter needs to be changed, repeat steps 2 through 4 for each required
parameter.
6. Once all parameters are set as required, confi rm the complete parametrization by pressing
and holding the
Parametrization is now complete. The PV and SV displays have returned to showing the cur-

rent temperature and the set temperature values respectively.
button for approximately 3 seconds to enter the "Parameter" menu.
1 x for 3 sec.
repeatedly
1 x briefl y
button for approximatedly 3 seconds.
1 x for 3 sec.
, and buttons to set a new para-
button.
Control
87