Husqvarna AUTOMOWER 420 Operator's Manual page 31

6. Use the arrow buttons and the OK button to
move through the menu structure
Lawn Coverage > Area 1-3 > More > Test .
7. Push the OK button.
8. Push the STOP button when the product is
at the distance you select to measure. The
distance shows in the display.
3.12.4.5 To disable or enable the Lawn Coverage
function
Lawn Coverage function for
Disable or enable the
each area.
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn Coverage > Area 1-3 > Disable .
3. Push the OK button.
4. Push the BACK button.
3.12.4.6 To reset the Lawn Coverage settings
Lawn Coverage settings for
You can reset the
each area and use the factory setting.
1. Do steps 1–3 in To get access to the menu
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Lawn Coverage > Area 1-3 > More >
Reset .
3. Push the OK button.
3.12.5 Methods for the product to find the
charging station
The product has 3 search methods to find the
charging station :
• Irregular - The product moves in the work
area until it finds the signal of the charging
station.
• Guide wire - The product moves in the work
area until it finds the guide wire. The product
moves along the guide wire to the charging
station.
• Boundary wire - The product moves in the
work area until it finds the boundary wire.
The product moves along the boundary wire
to the charging station.
The factory setting is set to mix the 3 search
methods. When the battery is low the product
starts to search for the charging station with the
1201 - 004 - 25.03.2020
irregular method for 3 min. After 3 min the
Settings > product changes search method to the guide wire
method. The product tries to find the guide wire
for 8 min. After 11 min the product changes
search method to the boundary wire method.
You can change the settings for how the product
finds the charging station to adapt to the work
area.
3.12.5.1 To set how the product finds the
charging station
You can make manual settings to make the
product search for the guide wire or the boundary
wire in 0–30 min from when the battery is low.
1. Do steps 1–3 in
on page 26 .
Installation
2. Use the arrow buttons and the OK button to
move through the menu structure
> To find the charging station > Overview of
search methods > Guide .
3. Push the arrow buttons to select 1 of the
guide wires.
4. Push the number buttons to set the time.
5. Push the OK button.
6. Push the BACK button.
7. Use the arrow buttons and the OK button to
Installation
move through the menu structure
> To find the charging station > Overview of
search methods > Boundary wire .
8. Push the number buttons to set the time.
9. Push the OK button.
10. Push the START button and close the hatch.
3.12.5.2 To do a test of the guide wire
1. Do steps 1–3 in
on page 26 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find charging station > Guide > More >
Test guide .
3. Put the product 3 m / 9 ft. from the boundary
wire.
4. Push the START button and close the hatch.
5. Make sure the product follows the guide wire
to the charging station.
6. Make sure the product docks with the
charging station.
To get access to the menu
Installation
Installation
To get access to the menu
Installation
Installation - 31