Information Messages - Husqvarna AUTOMOWER 420 Operator's Manual

6.3 Information messages

The list below shows a number of information messages that may be found in the
®
the Automower Connect app. Contact your local Husqvarna representative if the same message
appears often.
Message Cause
Low battery
The product cannot find the charging
station.
The battery is spent.
The charging station's antenna is de-
fective.
Settings restored
Confirmation that a
tings has been carried out.
Limited cutting
The cutting height adjustment cannot
height move.
Unexpected cut-
ting height adj
Limited cutting
height range
Cutting height
problem
Cutting height
blocked
Cutting system im-
The product has discovered vibrations
balance in the cutting disc.
Slope too steep
The product stopped because the slope
is too steep.
1201 - 004 - 25.03.2020
Action
Change the position of the guide wire.
Refer to
page 23 .
Make sure that the installation settings
about how to find the charging station
is correct. Refer to
product to find the charging station on
page 31 .
Replace the battery. Refer to
on page 43 .
Check if the indicator lamp in the
charging station flashes red. Refer to
Indicator lamp in the charging station
on page 54 . This problem requires ac-
tion by authorized service technician.
Reset all user set-
This is normal. No action required.
Examine the cutting height adjustment
and remove grass or other objects. If
the problem stays, speak to your ap-
proved servicing dealer.
Verify that the blades and screws are
intact and not worn out. Verify that all
blades are correctly mounted. Check
that no double blades are mounted on
any of the three blade positions.
Change the installation of the boundary
wire to not include this steep part of the
work area. Refer to
dary wire in a slope on page 19 .
Messages menu in
To install the guide wire on
Methods for the
Battery
To put the boun-
Troubleshooting - 51