Operating Mode Park; To Stop The Product; To Switch Off The Product; To Charge The Battery - Husqvarna AUTOMOWER 420 Operator's Manual

the product moves out of the charging station and
stops. The product is now prepared to start
operation, but needs confirmation from the
Secondary area mode, the
operator first. In the
product operates for a selected period of time or
until the battery is empty.
Note: If you want to cut the main area after the
battery is charged, set the product to
mode before you put the product in the charging
station.
4.3.3 Override schedule
The schedule settings can be temporarily
Override schedule . It is
overridden by selecting
possible to override the schedule for 24 h or 3
days. It is not possible to override a standby
period.
4.3.4 Spot cutting
Spot cutting function is activated with the
The
START button and is useful for quickly mowing
an area where the grass has been mown less
than in other parts of the yard. You must
manually move the product to the chosen area.
Spot cutting means that the product mows in a
spiral pattern in order to cut the grass in the area
where it was started. When this is done, the
product automatically switches back to
Secondary area .
or

4.4 Operating mode Park

Push the PARK button to select the following
operating modes:
Park until further notice
•
• Start with schedule
4.4.1 Park until further notice
The operation mode Park means that the product
goes back to the charging station where it stays
until a new operation mode is selected and the
START button is pushed.
4.4.2 Start again with next schedule
The product stays in the charging station until the
Schedule setting permits operation. This
next
operating mode is suitable if you want to cancel
an ongoing mowing cycle and allow the product
to stay in the charging station until the next day.
40 - Operation

4.5 To stop the product

1. Push the STOP button on top of the product.
The product stops and the blade motor stops.
Main area

4.6 To switch off the product

1. Push the STOP button on top of the product.
2. Set the Main switch to position

4.7 To charge the battery

Main area
When the product is new or has been stored for a
long period, the battery can be empty and needs
to be charged before starting. In the
mode, the product automatically alternates
between mowing and charging.
1. Set the Main switch to position
2. Place the product in the charging station.
Slide the product in as far as possible to
ensure proper contact between the product
and the charging station. Refer to contact
and charging plates in
page 4
WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery.
In the event of leakage of electrolyte
flush with water and seek medical help
if it comes in contact with the eyes etc.
Product overview on
1201 - 004 - 25.03.2020
0 .
Main area
1 .