Advertisement
1. Console arm frame
2. Audio alarm
7.
Connect the audio alarm to the main wire
harness (gasoline model only) or to the kit wire
harness (diesel model only).
8.
If your machine is equipped with an overflow
hose, loosen the worm-drive clamps and remove
the overflow hose
Note:
Discard the overflow hose and
worm-drive clamps.
1. Worm-drive clamp
9.
Remove the 4 bolts, washers, spacers, and
rubber washers that secure the tank cover to
the main hydraulic tank.
Note:
Save the bolts, spacers, and washers
for securing the leak detector tank to the main
hydraulic tank later.
10.
Remove the tank cover from the main hydraulic
tank.
11.
Remove the plug from the hydraulic tank (if
equipped); refer to
Figure 2
3. Threaded ring
(Figure
3).
Figure 3
2. Overflow hose
Figure
4.
1. Plug
12.
Insert the spout into the rubber grommet
4).
g016172
3
Installing the Leak Detector
Tank
Parts needed for this procedure:
1
Leak detector tank
1
Oil level sensor
1
O-ring
1
Valve hose
1
Tank valve hose
2
Hex-head bolt (1/4 x 2 inches)
1
Shield bracket
4
Hose clamp
1
Solenoid valve assembly
1
Straight fitting
2
90° hydraulic fitting
g236811
1
90° hydraulic fitting (beaded)
1
Delay timer (diesel model only)
1
Screw (5/8 inch)
1
Locknut
1
Oil level cover (diesel model only)
1
Oil level cover (gasoline model only)
1
Overflow hose
2
Worm-drive clamp
Procedure
1.
Find the appropriate oil-level cover for your
machine from loose parts.
3
Figure 4
2. Spout
g236699
(Figure
Advertisement
