Sony DVCAM DSR-PDX10 Service Manual page 200

2-2. Periodic Inspection and Maintenance
• Be sure to perform the following maintenance and inspection so
that the machine delivers its full performance and functions, and
to protect the machine and tape. Also, perform the following
maintenance items after completing the repair work, regardless
of the number of hours the machine has been operated by the
user.
2-2-1. Rotary Drum Cleaning
1) Press a wiping cloth (Ref. No. J-15) moistened with cleaning
fluid (Ref. No. J-14) lightly against the rotary drum. Rotate
the upper drum with a super-fine applicator slowly in the
counter-clockwise direction to clean the rotary drum.
Caution: Never rotate the rotary drum by turning on the main power of
the motor or rotate it in the clockwise direction. Never move the
cloth vertically against the head tip, as this will surely damage
the video head; the video head must not be cleaned by any other
different methods.
TG1
TG3
TG4
2-2-2.
1)
Note 1: Be careful not to allow oil or grease of the various link mechanisms
Note 2: Once the super-fine applicator has been moistened with alcohol,
Note 3: When cleaning the capstan shaft, be carefull not to move the oil
TG2
Fig. 6-2-2.
6-45
Tape Path System Cleaning (Refer to Fig. 6-2-2.)
Set the EJECT state. Clean the tape running path (TG-1, -2,
-3, -4, -5, -6 and -7, pinch roller and capstan shaft) and lower
drum with a super-fine applicator (Ref. J-16) moistened with
cleaning fluid.
to get on the super-fine applicator (Ref. J-16).
do not use it to clean other mechanical parts such as the tape guide.
However, the pinch roller is cleaned with alcohol.
seal. If the oil seal is moved, oil will leak.
Capstan shaft cleaning
Oil seal
Drum
DSR-PDX10/PDX10P
Capstan shaft
TG6
TG7
Pinch roller
TG5