Specifications; General Description; Characterstics - Panasonic KX-NS500AG Service Manual

KX-NS500AG

3 Specifications

3.1.

General Description

Main CPU
Power Input
Power Consumption (when fully mounted)
External Backup Battery
Memory Backup Duration
Dialling
Mode Conversion
Ring Frequency
Operating
Environment
Conference Call Trunk
Music on Hold (MOH)
External Paging
LAN Port
Extension Connection Cable
Air-cooling method
Dimension
Weight (when fully mounted)
*1 Except the 19-inch rack mounting equipment
3.2.

Characterstics

Terminal Equipment Loop Limit
Minimum Leakage Resistance
Maximum Number of Extension
Instruments per Line
Ring Voltage
Trunk Loop Limit
Hookswitch Flash/Recall Timing Range
Door Opener Current Limit
External Sensor Current Limit
Paging Terminal Impedance
MOH (Music on Hold) Terminal Impedance
Cortex A8 600 MHz
100 V AC to 130 V AC: 2.2 A/200 V AC to 240 V AC: 1.3 A;50 Hz/60 Hz
110 W
External battery port is not supported.
7 years
Trunk Dial Pulse (DP) 10 pps, 20 pps
Tone (DTMF) Dialling with Caller ID (FSK/DTMF)
1600  Maximum
Extension Dial Pulse (DP) 10 pps, 20 pps
Tone (DTMF) Dialling with Caller ID (FSK)
SLC1 and 2 port support PFT in combination with the LCOT1 and LCOT2 port connected to
an analogue trunk respectively.
DP-DTMF, DTMF-DP
20 Hz/25 Hz (selectable)
0 C to 40 C
Temperature
Humidity 10%to 90% (non-condensing)
From 10 x 3-party conference call to 4 x 8-party conference call
Maximum 8 ports (Level Control: 31.5 dB to +31.5 dB per 0.5 dB)
MOH: Selectable Internal/External Music Source port
Maximum 6 Ports (Volume Control: -15.5 dB to per 0.5 dB)
1 (for LAN connection)
SLT
DPT
PT-interface CS
PT-interface CS (High-density)
DSS Console and Add-on Key Module
FAN
430 mm (W) x 88 mm (H) x 367 mm (D)
Under 4.5 kg
• SLT: 600  including set
• Doorphone: 20 
15 000  maximum
1 for SLT
65 Vrms at 20 Hz/25 Hz depending on the Ringing Load
1600  maximum
24 ms to 2032 ms
24 V DC/30 V AC, 1 A maximum
Power to the external sensor is provided from the DPH2 card and must be grounded
through the DPH2 card. For the connection diagram.
The PBX detects input from the sensor when the signal is under 100 .
600 
10 000 
*1
6
10BASE-T/100BASE-TX (Auto MDI/MDI-X)
1-pair wire (T, R)
1-pair wire (D1, D2) or
2-pair wire (T, R, D1, D2)
1-pair wire (D1, D2)
4-pair wire (D1, D2)
1-pair wire (D1, D2)