Adjusting The Roller Scraper - Toro Groundsmaster 3500-D Operator's Manual

bench set 6 mm (1/4 inch) above that of the reels
cutting in the same area.
Important:
Access to the rear cutting units is
greatly improved by removing the cutting unit
from the machine. If the machine is equipped with
a Sidewinder® unit, side-wind the cutting units to
the right, remove the rear cutting unit, and slide
it out to the right side.
1. Lower the cutting deck to the ground, shut off
the engine, and remove the ignition key.
2. Loosen the bolt securing each height-of-cut
bracket to the height-of-cut plate (front and each
side) as shown in
1. Spacer
2. Height-of-cut plate
3. Beginning with the front adjustment, remove the
bolt.
4. While supporting the chamber, remove the
spacer (Figure 17).
5. Move the chamber to the desired height of
cut and install a spacer into the designated
height-of-cut hole and slot
6. Position the tapped plate in line with the spacer.
7. Install the bolt (finger tight).
Figure 17.
Figure 17
3. Height-of-cut bracket
(Figure 18).
Figure 18
8. Repeat steps
9. Tighten the 3 bolts to 41 N∙m (30 ft-lb).
Note:
Tighten the front bolt first.
Note:
Adjustments of more than 3.8 cm (1-1/2
inches) may require temporary assembly to an
intermediate height to prevent binding (e.g.,
changing from 3.1 to 7 cm (1-1/4 to 2-3/4 inches)
height of cut).
9
Adjusting the Roller
Scraper
Optional
No Parts Required
Procedure
The optional rear roller scraper works best when there
is an even gap of 0.5 to 1 mm (0.02 to 0.04 inch)
between the scraper and the roller.
1. Loosen the grease fitting and the mounting
g031577
screw (Figure
1. Roller scraper
2. Mounting screw
2. Slide the scraper up or down until you obtain a
gap of 0.5 to 1 mm (0.02 to 0.04 inch) between
the rod and the roller.
3. Tighten the grease fitting and screw to 41 N∙m
(30 ft-lb) in an alternating sequence.
g026184
19
4 to 7 for each side adjustment.
19).
Figure 19
3. Grease fitting
g031578