Toro Groundsmaster 3500-D Operator's Manual page 21

1. Speed-stop screw
Tilt-Steering Lever
Pull the tilt-steering lever back to tilt the steering wheel
to the desired position, then push the lever forward to
tighten (Figure 21).
Indicator Slot
Models 30807, 30839, and 30849 Only
The indicator slot in the operator platform indicates
when the cutting units are in the center position
(Figure 21) .
Angle Indicator
Models 30807, 30839, and 30849 Only
The angle indicator indicates the side-hill angle of the
machine in degrees (Figure
Ignition Switch
The ignition switch is used to start, stop, and preheat
the engine. The ignition switch has 3 positions:
O , O /P , and S
FF N REHEAT
O /P position until the glow-plug-indicator light
N REHEAT
goes out (approximately 7 seconds); then rotate the
key to the S position to engage the starter motor.
TART
Release the key when the engine starts
To shut the engine off, rotate the key to the O
position.
Note:
Remove the key from the switch to prevent
accidental starting.
Figure 22
21).
. Rotate the key to the
TART
(Figure
g031596
1. Parking brake
2. Cutting-unit-shift lever
3. Cutting-unit-drive switch
4. Alternator light
5. Oil-pressure light
6. Temperature light
Throttle
Move the throttle forward to increase the engine
speed and rearward to decrease the engine speed
(Figure 23).
Cutting-Unit-Drive Switch
The cutting-unit-drive switch has 2 positions: E
and D
ISENGAGE
solenoid valve on the valve bank to drive the cutting
units (Figure
Hour Meter
23).
The hour meter indicates the total hours of machine
FF
operation. The hour meter starts to function whenever
the key switch is in the O
Cutting-Unit-Shift Lever
To lower the cutting units to the ground, move the
cutting-unit-shift lever forward. To raise the cutting
units, pull the shift lever rearward to the R
(Figure 23).
Note:
The cutting units do not drop unless the engine
is running.
21
Figure 23
7. Glow-plug-indicator light
8. Hour meter
9. Throttle
10. Ignition switch
11. Lift-lever lock
. The rocker switch operates a
23).
position
N
g031597
NGAGE
(Figure 23).
position
AISE