Page 1
MANUEL D’INSTALLATION INSTALLATIEHANDLEIDING Model: PC-2H2 Read and understand this manual before using this air conditioner. Keep this manual for future reference. Lea cuidadosamente este manual antes de poner en marcha el equipo de aire acondicionado. Guarde este manual en un lugar seguro por si necesita consultarlo en el futuro.
Page 3
§ In case that a service work such as repair, maintenance, etc. by opening and closing doors is required, contact your distributor or dealer of HITACHI. § where the air from the air conditioner is directly § DO NOT modify the electrical wiring. It may cause serious discharged accidents.
Page 4
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> 1.1. BEFORE INSTALLATION Check the contents and the number of the accessories in the packing. Holding Bracket 1 Remote Control 2 screws ø4x16L 1 Remote 1 Ring Core Switch, for Operation For fixing the...
Page 5
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> Ë Connect the cable to the PCB connector (yellow) of Ë Mounting procedures. the controller, run the cable through the groove at Step 1: Insert the hooks of the controller to the the backside of the casing and draw out the cable holes on the top of the holding bracket.
Page 6
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> 1.4.3. ONE REMOTE CONTROL SWITCH FOR MULTIPLE UNITS In case that a longer cable is required, the additional field- This remote control switch can control sixteen units, as the supplied cable shall be connected as following procedure.
Page 7
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> 1.5. TEST RUN PROCEDURE BY REMOTE CONTROL SWITCH É Turn ON the power source of the Indoor and Outdoor Units Ê Set the TEST RUN mode by remote control switch. Depress the "MODE" and the "CHECK" switches Operation Lamp simultaneously for more than 3 seconds.
Page 8
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> 2. CHECK FUNCTION USING THE REMOTE CONTROL 2.1. ALARM CODES Indication Trouble Possible Causes Action RUN lamp Flashes for Failure in Transmission Remote cable broken Locate the cause and 2 Seconds Between Indoor Unit and repair.
Page 9
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> 2.2. OPTIONAL FUNCTION SETTING NOTES: The indoor unit can be selected among the indoor units connected to the remote control switch. The remote control switch is changed to the optional setting In case that both the indications of the address and the mode by the following procedures.
Page 10
INSTALLATION OF REMOTE CONTROL SWITCH <PC-2H2> n Selection of Other Indoor Unit At the optional setting mode, press the "TIME ∇" switch or the "TIME ∆" switch, the condition of the remote control switch is changed so that the indoor unit can be selected to set the optional function described in the item (b) of "Selection of...