Philips 9000 Series Manual page 14

14
English
Removing or attaching the click-on attachments
1 Make sure the appliance is switched off.
2 Pull the attachment straight off the appliance (Fig. 25).
Note: Do not twist the attachment while you pull it off the
appliance.
3 Insert the lug of the attachment into the slot in the top of the
appliance. Then press down the attachment to attach it to the
appliance ('click') (Fig. 26).
Using the trimmer attachment
You can use the precision trimmer attachment to touch up your
beard, sideburns and moustache.
1 Attach the attachment to the appliance ('click') (Fig. 26).
2 Switch on the appliance.
The display lights up for a few seconds.
3 Hold the trimmer attachment perpendicular to the skin and move
the appliance downwards while you exert gentle pressure (Fig. 27).
4 Clean the attachment after use (see 'Cleaning and maintenance').
Using the beard styler attachment with comb
You can use the beard styler attachment with the comb attached to
style your beard at one fixed setting, but also at different length
settings. You can also use it to pre-trim any long hairs before shaving
for a more comfortable shave.
The length settings on the beard styler attachment correspond to the
remaining hair length after cutting and range from 1 to 5mm (3/64 -
3/16in).
1 Attach the attachment to the appliance ('click') (Fig. 28).
2 Slide the comb straight into the guiding grooves on both sides of
the beard styler attachment ('click') (Fig. 29).
3 Press the length selector and then push it to the left or right to
select the desired hair length setting (Fig. 30).
4 Switch on the appliance.