Philips 9000 Series Manual page 20

20
English
Hold the shaving head holder in your hand when you reinsert the
shaving heads and reattach the retaining rings (Fig. 67). Do not
place the shaving head holder on a surface when you do this, as
this may cause damage.
Each retaining ring has two recesses that fit exactly into the
projections of the shaving head holder. Turn the ring clockwise
until your hear a click to indicate that the ring is fixed (Fig. 66).
11 Attach the shaving head holder to the bottom part of the shaving
unit ('click') (Fig. 55).
Cleaning the click-on attachments
Never dry trimmer or beard styler attachments with a towel or tissue,
as this may damage the trimming teeth.
The accessories supplied may vary for different products. The box
shows the accessories that have been supplied with your product.
Cleaning the trimmer attachment
Clean the trimmer attachment after each use.
1 Switch on the appliance with the precision trimmer attachment
attached.
2 Rinse the attachment under a warm tap (Fig. 68).
3 After cleaning, switch off the appliance.
4 Carefully shake off excess water and let the attachment air-dry
completely.
Tip: For optimal performance, lubricate the teeth of the attachment
with a drop of sewing machine oil regularly.
Cleaning the beard styler attachment
Clean the beard styler attachment after each use.
1 Pull the comb off the beard styler attachment (Fig. 69).
Note: Grab the comb in the center to pull it off the beard styler
attachment . Do not pull at the sides of the comb (Fig. 32).
2 Rinse cut hairs off the cutting unit with lukewarm water (Fig. 70).
3 Rinse cut hairs off the comb.