Philips 9000 Series Manual page 21

4 Remove the cutting unit from the beard styler attachment (Fig. 71).
By pushing the cutting unit off the beard styler attachment, you
can remove any hairs that have accumulated inside the beard
styler attachment. You can also rinse the bottom of the cutting
unit.
5 Rinse cut hairs out of the beard styler attachment (Fig. 72).
6 Carefully shake off excess water and leave the comb, cutting unit
and beard styler attachment to air-dry before you use them again.
7 When the cutting unit is dry, attach it to the beard styler
attachment (Fig. 73).
8 When the comb is dry, attach it to the beard styler attachment (Fig.
74).
9 For optimal performance, lubricate the teeth of the attachment
with a drop of sewing machine oil every six months.
Cleaning the cleansing brush attachment
Clean the cleansing brush attachment after each use.
1 Switch off the appliance.
2 Detach the brush head from the attachment holder (Fig. 75).
3 Clean the parts thoroughly with warm water and soap.
4 Dry the cleansing brush attachment with a towel.
Storage
1 Store the appliance in the pouch supplied (Fig. 76).
Note: Make sure the appliance is dry before you store it in the
pouch.
2 Put the protection cap on the cleansing brush attachment to
protect it from dirt accumulation (Fig. 77).
Replacement
Replacing the shaving heads
For maximum shaving performance, we advise you to replace the
shaving heads every two years (Fig. 78). Replace damaged shaving
heads immediately.
21
English