C Adjustment Of The Presser Foot Pressure - Mitsubishi Electric LT2-2250-B1T Instruction Manual

HOW TO USE
・Adjustment of the needle up and down position
When the needle is lifted 2.4 mm from the lowest
position, adjust the needle position so that the gap
between the top of needle eye and the tip of the
hook is 1.0 to 2.0 mm.
( 1 ) Remove the set screw Ⓐ.
( 2 ) Rotate one turn the needle clamp Ⓑ
(Adjustment pitch is 0.6 mm), or rotate half
turn the stopper Ⓓ with taking off the set
screw Ⓒ (Adjustment pitch is 0.3 mm).
( 3 ) Return the needle clamp Ⓑ to the position
before adjusting and fully tighten the set
screw Ⓐ and Ⓒ.
C Adjustment of the presser foot
pressure
Adjust the presser foot pressure by turning the
pressure adjusting screw.
Set screw Ⓒ
Set screw Ⓐ
Stopper Ⓓ
Needle clamp Ⓑ
Pressure adjusting screw
Light fabric
Weaken
— 10 —
Heavy fabric
Strengthen