Table of Contents
Advertisement
66/84
Disassembly and replacement
Bosch Rexroth AG, CytroPac, RE 51055-B/06.17
12 Disassembly and replacement
Only assemble device parts if it is required to carry out the necessary work. In
general, all disassembled parts should be reassembled properly at the intended
position.
12.1 Preparing for disassembly
▶
Ensure sufficient stability of the hydraulic power unit.
▶
Observe the weight and the position of the center of gravity of the hydraulic
power unit.
▶
Do not loosen the fixation of the hydraulic power unit before the stability of the
machine is ensured.
▶
Prior disassembly, drain the hydraulic fluid from the hydraulic power unit as
described in chapter 11 "Decommissioning".
▶
Use the intended eyebolt. See fig. 5.
▶
Check secure fitting of the eyebolt if the hydraulic power unit is to be transported
after disassembly.
▶
Please note that the hydraulic power unit may be mounted on an optional
installation plate. See fig. 10.
▶
To remove the hydraulic power unit from the installation plate, untighten the
screw. See fig. 8.
Safety measures:
▶
Always observe applicable instructions for the overall machinery/system.
▶
Unless these instructions provide different information, proceed as follows:
– Carry out decommissioning as described in chapter 11 of these operating
instructions.
– Unauthorized personnel must not be allowed access to the working area.
12.2 Disassembly process
▶
For disassembly, carry out the work steps described in chapter 7 "Installation" in
reverse order.
▶
Hydraulic fluid will run out of the hydraulic line system of the hydraulic power
unit or hydraulic system even after draining. For this reason, close all outlets of
lines with suitable blanking plugs.
After disassembly, observe the information on safe transport of the product in
chapter 6 "Transport and storage".
Hide quick links:
Advertisement
Table of Contents
