10. Service And Maintenance; Service - Husqvarna DC 6000 Workshop Manual

10. SERVICE AND MAINTENANCE

The following lists contains service procedures to be performed on the CD 6000 by the servicing workshop. Mainte-
nance procedures normally performed by the owner (daily service) are described in the Operator's manuals.

Service

Check that the machine's safety equipment is unharmed.
See instructions in section "Machine's safety equipment�"
Make sure the cord and the extension cord are intact and in good
condition.
Clean the machine exterior�
Check the filter and shake out the dust when needed. If necessary, wash the
filter with water according to Husqvarna's recommendations.
Never clean the filter using air pressure.
See Cleaning / replace filters in OM
Check the dust level inside the filter housing.
Check the cyclone and holder.
Check the rubber sealing on the cyclone�
Make sure the container net on the cyclone is clean�
SERVICE AND MAINTENANCE
Daily Weekly
X
X
X
X
X
X
X
X
10
29