ABB SM500F Instruction page 3

Referring to Fig. 4.6:
9. Remove 4 Torx screws K securing the display mounting
plate and remove the plate complete with display.
Fig. 4.6 Removing the display mounting plate
Referring to Fig. 4.7:
10. Remove 2 display securing screws L and lift the display
clear of the mounting plate, ensuring the flexi-cable and
inverter cable clear slots M in the mounting plate.
Fig. 4.7 Removing the display
Referring to Fig. 4.8:
11. Remove flexi-cable N from the display and attach the
flexi-cable to the new display (if not already fitted).
Fig. 4.8 Removing the display
Referring to Fig. 4.7:
12. Carefully route the flexi-cable through its respective slot
M in the mounting plate and position the display on the
mounting plate. Secure the display to the mounting plate
with 2 display securing screws L.
SM500F paperless recorder | Color display replacement (instruments manufactured from July 2016) | IN/RandC/005-EN Rev. A
13. Remove the protective film from the front of the display and
clean the display and the inside of the door window
thoroughly.
Referring to Fig. 4.9:
14. Route the keypad membrane cable O through the slot in
the display mounting plate and position the mounting plate
in the door assembly.
Fig. 4.9 Routing the keypad membrane cable
Referring to Fig. 4.6:
15. Secure the display mounting plate to the door using 4 Torx
screws K.
Referring to Fig. 4.5, page 2:
16. Position the processor board into its housing and
reconnect the keypad membrane cable J, display
flexi-cable I and processor board flexi-cable H.
Referring to Fig. 4.4, page 2:
17. Refit the door assembly rear cover and secure it using the
6 Torx screws G.
Referring to Fig. 4.3, page 2:
18. Align the hinges on the door assembly with the hinge lugs
on the case and secure using the 2 slotted spring (Bissel)
pins F.
Referring to Fig. 4.2, page 2:
19. Reconnect the processor board flexi-cable E to the
motherboard.
Referring to Fig. 4.1, page 2:
20. Refit the cable clamp and secure it with 2 Torx screws D.
21. Refit the inner cover plate, ensuring lugs P are located
correctly in the slots in the case and secure with a captive
screw C. Refit the tamper evident seal (if required).
22. Close and lock the door.
23. Restore the power supply to the recorder.
3