Huawei RTN 380H Quick Installation Manual page 15

Appendix
Installing the Aiming Telescope
1 Remove the ground terminal from
the equipment.
(Optional) Install support rob B.
3
Use socket head
cap screws M6 to
fasten support rods.
NOTE
•Install only support rob A if a 0.2 m or 0.3 m antenna is used.
•Install both support rob A and support rob B if a 0.6 m antenna is used.
28/29 >>
2 Install support rob A.
Captive screws
Loosen the locking ring, adjust the support
4
plate for easy installation, and slightly fasten
the locking ring to prevent the objective lens
tube from moving.
Locking ring
Loosen
Tighten
5 Fix the aiming telescope
onto support rods.
Adjust the equipment horizontally or vertically until the target tower or pole is aligned with the central
7
point of the cross.
Support plate
6 Loosen the locking ring, adjust the aiming
telescope to a proper position, and tighten the
locking ring.
Hand wheel