Huawei PowerCube 500 Manual page 3

4
Installing a Camera and Cables
4.1 Installing a Camera
For the camera installation method, see the documents delivered with the equipment.
4.2 Installing Camera Cables
For the cable connections at the camera side, see the documents delivered with the equipment. Reserve the other ends of cables.
5
Installing PV Modules and Cables
5.1 Installing a PV Module Support
In the northern hemisphere, PV modules face south. In the southern hemisphere, PV modules face north.
1. Remove the connective kit.
4. Install the PV module support.
2. Adjust the PV module direction based on
the PV module direction principles, and
then install the connective kit.
5. Measure the PV module
hole spacing L.
3. Adjust the PV module tilt angle based on the site
latitude, and secure the PV module support base.
6. Determine the beam mounting holes based on L
and install the beams.
3
Site
PV Module
Latitude
Tilt Angle
(Degree)
0–15 15°
16–25 25°
26–30
35°
31–45 45°
NOTE
When installing beams,
keep the slots on the
beams face outwards to
facilitate operation.