Installing The Rear Guard - Toro ProCore SR54 Operator's Manual

•
Position A - Maximum depth
•
Position B - Depth is decreased 38 mm (1-1/2
inches) from Position A
•
Position C - Depth is decreased 76 mm (3 inches)
from Position A
15

Installing the Rear Guard

Parts needed for this procedure:
1 Rear guard
4 Screw (3/8 x 3-1/4 inch)
12 Flat washer (0.438 x 1 inch)
4 Locknut
2 End cap
Procedure
1. Insert the end caps into the ends of the rear
guard tubes (Figure
Figure 31
32).
g016181
1. Rear guard
2. End cap
2. Align the holes in the rear guard mounting tubes
with the holes in the aerator side plates
32).
Note:
On SR54-S and SR70-S models, mount
the ends of the tubes to the lower side plate
mounting holes if the aerator tine depth is set in
Position A
holes for depth setting Positions B or C.
3. Secure the guard mounting tubes to the side
plates with 4 screws, flat washers and nuts
(Figure 32).
18
Figure 32
3. Upper mounting hole
4. Lower mounting hole
(Figure 33). Use the upper mounting
Figure 33
g016186
(Figure
g016181