Removing The Storage Stands; Installing The Latch Lock - Toro ProCore SR54 Operator's Manual

Note:
Use the remaining washers, as required,
to fill any gap between the tubes and the aerator
side plates.
16
Removing the Storage
Stands
No Parts Required
Models SR54 and SR70
1. Raise the aerator roller(s) 7.5 to 15 cm (3 to 6
inches) off the ground. Place support blocks
under the roller(s).
2. Remove the bolts, lock washers, and nuts
securing the storage stands to each end of the
aerator (Figure 34).
1. Bolts
2. Lock washer
3. Remove the storage stands.
4. Use the storage stands whenever the aerator is
removed from the tractor.
Model SR72
1. Raise the aerator roller(s) 7.5 to 15 cm (3 to 6
inches) off the ground. Place support blocks
under the roller(s).
2. Remove the bolts, lock washers, and nuts
securing the storage stands to each end of the
aerator (Figure 35).
Figure 34
3. Nut
4. Storage stand
1. Bolts
2. Lock washer
3. Remove the storage stands.
4. Use the storage stands whenever the aerator is
removed from the tractor.
Note:
When installing the storage stands,
ensure that they are mounted to the inside of the
roller plates so that the lower frame tube rests
on the top of the stands.
Note:
Models SR54-S and SR70-S do not have
storage stands.
17

Installing the Latch Lock

CE Only
g010857
Parts needed for this procedure:
2 Lock plate
2 Tap bolt
2 Retaining ring
Procedure
1. Position the latch plate over the hood latch while
aligning the mounting hole with the hole in the
side plate
19
Figure 35
3. Nut
4. Storage stand
(Figure 36).
g010967