Removing The Processor - Dell Dimension XPS Manual

Hide thumbs Also See for Dimension XPS:

Table of Contents

Documentation

8. Install the heat sink:

a. Insert the notched end of the heat sink onto the end of the retention base that is opposite the hinge.

b. Lower the heat sink until it fits securely in the base.

c. When the heat sink is secured, pivot the retention module clip back until the tab snaps into place to secure the

heat sink.

9. If you installed a processor replacement kit from Dell, return the original heat sink assembly and processor to Dell in

the same package in which your replacement kit was sent.

10.

Replace the airflow

shroud.

11.

Close the computer

cover.

NOTICE:

To connect a network cable, first plug the cable into the network wall jack and then plug it into the

computer.

12. Connect your computer and devices to electrical outlets, and turn them on.

Removing the Processor

http://support.dell.com/support/edocs/systems/dimxpsg2/en/SM/parts.htm (23 of 37) [3/26/2008 3:57:09 PM]

Table of Contents