Storing The Iron - Toshiba TA-FVW100 Instruction Manual

Charging the iron
When not using the iron, or when straightening the clothes, return
z z
the iron to the stand so it goes straight onto the contacts.
If the temperature lamp is flashing, wait until it stops flashing and
z z
stays lit before you use the iron.
Attention
If you change the temperature from HIGH to LOW, wait until the temperature lamp stops flashing and stays lit before you use the
z z
iron.
(When lowering the temperature from [HIGH] to [LOW], the auto power off function may be activated if the temperature does not
readily fall. If the power turns off, reset the temperature setting.
About sparks on the stand contacts
The cordless iron is charged to maintain the set temperature, when you put it on the stand.
z z
When you put the iron back on the stand or when you remove it, the contacts
may spark, but this is not abnormal.

Storing the iron

Do not leave the power cord attached
when you store the iron
Always remove the power cord before storing the
iron.
1
Turn off the power
Place the iron correctly on the
stand, and press the SET / OFF
button to [OFF].
3
Remove water (steam irons only)
Remove water that is still in the water tank
to prevent the inside of the soleplate from
corroding.
1
Put the Steam / Dry lever in the [
position, and remove the water tank.
2
Open the lid of the fill opening and
drain out all the water, then put the
water tank on the iron.
Attention
You can store the iron while it is hot, but drops of water may form on the case.
z z
Do not place the case on while the power is on.
z z
If you place the iron in the case while the soleplate is still hot, do not pick it up. It may damage the case.
z z
2
Temperature
lamp turns off
1
2
4
Close the lid of the fill opening,
place the iron correctly on the stand,
and securely place the case on top.
Dry]
11
Straight onto the
contacts until it
stops
Stand contacts
Place the case securely on the stand
If only one side of the case is hooked, the iron and
stand will fall down when you pick it up, and may
cause an injury.
Unplug the power cord
Unplug the power
plug from the electrical
outlet.
Unplug the power
cord from the stand.
Storing
Hold the
plug!