Wiring The Dvr; Accessing The Dvr Back Box - GE MobileView User Manual

MobileView User Manual
3.2 W
IRING THE
Wire connections between the DVR and auxiliary devices are made to the DVR's back box (Figure 24).
Wires enter through the cable-entry hole protected by the splashguard.
Camera and keypad outputs
(J9 terminal block)
BNC connectors (video inputs J1 – J8)
Modem port (J10 serial port)
Ethernet connector (optional)
Ferrite clamp on 4-conductor power
cable connected to J3
Alarm inputs/outputs, status
indication, modem, and impact sensor
(J11 terminal block)
Figure 24. DVR back box connections
3.2.1 A
CCESSING THE
Note: Use the splashguard only when the unit is mounted in an exposed area.
See Figure 25 and perform the
following:
1) Remove the back box's two
cover screws.
2) Remove the back box from
the DVR.
3) Remove the splashguard by
unscrewing the two screws
inside the connection box.
1036564B / October 2002
DVR
DVR B B
ACK OX
Figure 25. Splashguard (
3 DVR Installation and Wiring
Four-pin Molex
(J3 power management board)
EM shutdown resistor
S1 switch
S2 switch
Audio connections (J12 terminal block)
) and cover screws ( ) on DVR back box
19