Step
1
Installing the Drive Wheels
Parts needed for this step:
2
Wheel
8
Lug nut
Procedure
Mount wheels to wheel motor hubs with 8 lug
nuts. Torque bolts to 55 ft-lb (75 N⋅m) (Figure 3).
Figure 3
1. Wheel
2. Hub
Step
2
Installing the Upper Handle
Parts needed for this step:
1
Handle assembly
4
Flanged bolt, (3/8 x 1 inch)
4
Flange nut, (3/8 inch)
Procedure
1. Align handle with upper mounting holes in
rear frame (Figure 4).
3. Lug nut
2. Secure the handle at each upper mounting hole
with a flange bolt (3/8 x 1 inch) and flange nut
(Figure 4).
3. Select the high, medium, or low position for
the lower mounting hole. Secure the handle at
each lower mounting hole with a flange bolt
(3/8 x 1 inch) and flange nut (Figure 4).
Note: The handle position can be adjusted to
match the operator's height preference.
1. Upper handle
2. Rear frame
Step
3
Installing the Left Control
Rod
Parts needed for this step:
1
Left control rod
1
Hairpin cotter pin
1
Clevis pin
1
Rod tting
Procedure
1. Slide clevis pin through rod fitting and
mounting hole in control bracket from the
11
Figure 4
3. Flange bolt, (3/8 x 1 inch)
4. Flange nut, (3/8 inch)