To Push the Machine
Note: Always push the machine by hand. Never
tow the machine because hydraulic damage may
occur.
1. Disengage the power take off (PTO) and turn
the ignition key to off.
2. Loosen the jam nuts and rotate the by-pass
valves open 5 turns to push the machine. This
allows hydraulic fluid to by-pass the pump and
the wheels to turn (Figure 16).
Important: Rotate by-pass valve a
maximum of 5 turns so the valve does not
come out of the body causing fluid to run
out.
To Operate the Machine
If the by-pass valve is opened to push the machine
by hand, an adjustment is required for machine
operation. Refer to Adjusting the By-pass Valve.
Note: The machine will not drive unless the
by-pass valves are properly adjusted.
Figure 16
1. By-pass valve
2. Jam nut
24