Removing The Oven Carriage; Removing The Door Cover; Removing And Installing The Door Panels - Siemens HC854 83 Series Instruction Manual

Area Cleaning agents
Glass cover for the Hot soapy water:
oven light Clean with a dish cloth.
Seal Hot soapy water:
Do not remove. Clean with a dish cloth. Do not scour.
Accessories Hot soapy water:
Soak and clean with a dish cloth or
brush.
Plinth drawer Hot soapy water:
Clean with a dish cloth.

Removing the oven carriage

In order to clean the cooking compartment more easily, you
can remove the oven carriage. Slide out the oven carriage to
the stop. Hold it on the left and right, raise it slightly and then lift
out. Place it carefully on a flat surface. There are delicate
components on the underside of the oven floor.

Removing the door cover

The oven carriage cover can become discoloured. To carry out
thorough cleaning, you can remove the cover.
Open the oven carriage.
1.
Unscrew the oven carriage cover. To do this, undo the left
2.
and right screws (figure A). Hold the outer panel steady with
your hand. The glass tilts slightly forwards.
Remove the cover (figure B).
3.
$
Make sure that the oven carriage is not closed while the
cover is removed. The outer panel may be damaged.
Clean the cover with a stainless-steel cleaning agent.
Replace the cover and secure it in position.
4.
Close the oven carriage.
5.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels from the
oven door.
When removing the inner panels, pay attention to the order in
which the panels are removed. In order to reassemble the
panels in the correct sequence, follow the number which
appears on each panel.
Removal
Pull out the oven carriage.
1.
Unscrew the cover at the top of the oven carriage. To do this,
2.
undo the left and right screws (fig. A).
20
%
Take hold of the panels on the left and right-hand side, tilt
3.
forward slightly and pull up and out (fig. B).
Place on a cloth with the handle facing downwards. The inner
panel with the hooks remains fitted to the oven carriage.
$
Unscrew the retaining carriers on the right and left (fig. C).
4.
Remove the upper panel and remove the clips for cleaning.
&
Remove the lower panel.
5.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
Insert the lower panel downwards at an angle (fig. A).
1.
Slide in the upper panel (fig. B).
2.
$
Fit the retaining carriers on the right and left of the upper
3.
panel, so that they are over the screw holes. Screw both
carriers tight again (fig. C).
&
Insert the panels into the retainer on the oven carriage.
4.
Put the cover back in place and screw it on. If it is not
5.
possible to screw on the cover, check whether the panels are
correctly seated in the retainer.
%
%