Advertisement
Quick Links
Weight Kit for 8-Blade or 11-Blade DPA Cutting Unit
with 5in Reel
Reelmaster
Model No. 03484
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Weight
O-ring
Bolt
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Determining the End-Weight
Orientation
Refer to
Figure 1
to determine the position of the end weight
and reel motors.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3550 or 3555 Series Traction Unit
Qty.
–
Determine the position of the end-weight and reel motors.
5
5
Install the weight onto the cutting units.
10
Register at www.Toro.com.
7
6
7
4
7
6
2
Figure 1
1. #1 cutting unit
2. #2 cutting unit
3. #3 cutting unit
4. #4 cutting unit
Original Instructions (EN)
All Rights Reserved *3388-941* A
Printed in the USA.
Form No. 3388-941 Rev A
Installation Instructions
Use
6
7
1
5
7
6
3
5. #5 cutting unit
6. Reel motor
7. End-weight
6
g027620
Advertisement
Related Manuals for Toro 03484
Summary of Contents for Toro 03484
- Page 1 Weight Kit for 8-Blade or 11-Blade DPA Cutting Unit with 5in Reel Reelmaster ® 3550 or 3555 Series Traction Unit Model No. 03484 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty.
- Page 2 Installing the End-Weight Install the end-weight onto the cutting unit (Figure Note: Use Figure 1 to determine where to properly place the end-weight. g027926 Figure 2 1. Bolt 3. O-ring 2. Counterweight Note: Torque the bolts to 37-45 N-m (27–33 ft-lb).