Table of Contents
Advertisement
Change the fuses of the optional Book Stacker
Introduction
The Book Stacker has 2 fuses at the power input connector (see
optional Book Stacker on page
If either fuse has blown, the Book Stacker will not operate.
Required tools
Fuse description: 3A, HRC Quick Acting, F
IMPORTANT
Turn OFF the machine and remove the mains power supply cable before you change the fuses.
This machine uses two fuses in parallel.
IMPORTANT
To avoid the risk of fire, replace fuses using only the same type and rating.
Procedure
1.
Turn OFF the Book Stacker.
2.
Disconnect the Book Stacker from the power supply.
3.
Check each fuse.
4.
If the fuse is blown, then replace with a fuse of the correct specification.
NOTE
If the fuse blows again, call your service engineer.
15).
Chapter 6 - Error Conditions, Problems and Solutions
Change the fuses of the optional Book Stacker
The mains input panel of the
107
Advertisement
Table of Contents
