Table of Contents
Advertisement
RECORDING FROM STEREO COMPONENTS, ETC.
(pages 30 - 33)
Manual recording
(pages 30 - 32)
[Operate with the multi link station.]
1. Connect external equipment to the OPTICAL/LINE IN
terminal on the multi link station.
2. Insert a recordable MiniDisc.
3. Place the main unit on the multi link station.
4. Press the REC button.
5. Select an appropriate recording mode (page 125).
6. Start playback on the external equipment and adjust
the recording level by pressing the
Adjust it so the level meter fluctuates between – 4 dB
and 0 dB at the maximum level.
7. Set the external equipment to the pause mode. (Select
the track to be recorded.)
8. Press the
button.
9. Resume playback on the external equipment and start recording.
To interrupt recording:
Press the
button while recording.
The track number increases by one.
To resume recording, press the
To stop recording:
Press the
button while recording.
TOC information is recorded.
To turn off the power:
Press the
button while in the stop mode.
Synchronous recording
1. Press the REC button.
2. Select an appropriate recording mode (page 125).
3. Adjust the recording level by pressing the
button.
4. Press the MENU button.
5. Select "SYNC REC" by pressing the
ton, and then press the ENTER button.
6. Select "ON" by pressing the
then press the ENTER button.
7. Recording starts when the unit detects sounds from the
or
button.
connected equipment.
Note:
If the silence lasts for 3 seconds or more, the unit enters
the recording pause mode.
When the unit detects sounds again, a new track number
will be created and recording will start.
To cancel synchronous recording:
Press the
To perform synchronous recording in the last setting:
button again.
Press the REC button to enter the recording pause
mode and then press it again for 2 seconds or more.
1-BIT PORTABLE MINIDISC RECORDER IM-DR80
(pages 32 - 33)
or
button while recording.
or
or
but-
button, and
123
Advertisement
Table of Contents
