Dtc Check; Dtc Clearance - Suzuki RA410 Manual

3
Condition between diagnosis switch terminal
and ground terminal
Open
Ground
"a" "b"
"a": more than 4 seconds
"b": within 2 seconds
"c": about 1 second

DTC CHECK

1) Remove glove box.
2) Apply chocks to wheels, set shift lever to neutral position and
3) Start engine.
4) Connect positive probe of analog type voltmeter (1) to diagnosis
4 1
5) Read deflection of voltmeter indicator which represents DTC
6) After completing the check, turn ignition switch to OFF position
2

DTC CLEARANCE

1) Remove glove box.
2) Turn ignition switch to ON position.
3) Using service wire, short diagnosis output terminal (1) to ground
3
4) After keeping them connected for 4 seconds or longer, discon-
1
5) Perform DTC CHECK and confirm that normal DTC (DTC 12)
2
within 10 seconds
"c"
ELECTRICAL POWER STEERING (P/S) SYSTEM 3B1-7
pull parking brake fully.
output terminal (2) and negative probe to ground terminal (3) of
monitor coupler (4).
and write it down. When more than 2 DTCs are stored in
memory, deflection for each DTC is repeated three times start-
ing with the smallest DTC number in increasing order.
For details and example of DTC, refer to DTC TABLE.
and disconnect voltmeter probes from monitor coupler.
terminal (2) of monitor coupler (3).
nect one end of service wire (open) and within 2 seconds after
that, make the disconnected end of service wire contact where
disconnected (short) and repeat these actions (open and short)
at least five times within 10 seconds.
is displayed and not malfunction DTC.