Table of Contents
Advertisement
1. Diagnosis connector
3. Diag. switch terminal
(6 pins connector)
4. Service wire
2. Ground terminal
Example: When right-front wheel speed sensor circuit opens (DTC 21)
Voltmeter indicator
(or "ABS" warning
HIGH
lamp)
(ON)
LOW
(OFF)
EBD WARNING LAMP (BRAKE WARNING
LAMP) CHECK
NOTE:
Perform this check on a level place.
1) Turn ignition switch ON with parking brake applied.
2) Check that brake warning lamp is turned ON.
3) Release parking brake with ignition switch ON and check that
1. EBD warning lamp
(brake warning lamp)
"ABS" WARNING LAMP CHECK
1) Turn ON the ignition switch.
2) Check that "ABS" warning lamp lights for about 2 seconds and
DIAGNOSTIC TROUBLE CODE (DTC) CHECK
(USING "ABS" WARNING LAMP)
1) Using service wire, connect diag. switch terminal of diagnosis
2) Turn ignition switch ON.
3) Read flashing of "ABS" warning lamp which represents DTC as
ANTILOCK BRAKE SYSTEM (ABS) (OPTIONAL) 5E1-11
EBD warning lamp (brake warning lamp) goes off.
If it doesn't go off, go to "TABLE-E" in this section.
then goes OFF.
If anything faulty is found, advance to Diagnostic table – A, B or
C.
connector to ground.
shown in example below and write it down. When more than 2
DTC's are stored in memory, deflection and flashing for each
DTC is repeated three times starting with the smallest DTC num-
ber in increasing order.
For details of DTC, refer to "DTC Table".
Time (sec.)
- Quick Links:
- Engine
Hide quick links:
Advertisement
Chapters
Table of Contents
