Precaution For Installing Mobile Communication Equipment - Suzuki sq-416-420-625 Service Manual

0A-16 GENERAL INFORMATION
D Poor terminal-to-wire connection.
Check each wire harness in problem circuits for poor connection
by shaking it by hand lightly. If any abnormal condition is found,
repair or replace.
D Wire insulation which is rubbed through, causing an intermittent
short as the bare area touches other wiring or parts of the vehicle.
D Wiring broken inside the insulation. This condition could cause
continuity check to show a good circuit, but if only 1 or 2 strands
of a multi-strand-type wire are intact, resistance could be far too
high.
If any abnormality is found, repair or replace.
PRECAUTION FOR INSTALLING MOBILE
COMMUNICATION EQUIPMENT
When installing mobile communication equipment such as CB (Citi-
zens-Band)-radio or cellular-telephone, be sure to observe the fol-
lowing precautions.
Failure to follow cautions may adversely affect electronic control
system.
D Keep the antenna as far away as possible from the vehicle's elec-
tronic control unit.
D Keep the antenna feeder more than 20 cm (7.9 in.) away from
electronic control unit and its wire harnesses.
D Do not run the antenna feeder parallel with other wire harnesses.
D Confirm that the antenna and feeder are correctly adjusted.